Using the Right Power Supply Setup
hi there,
i'm finishing design project of mine, , want see if final idea feasible - if want power 2 12v, 1.3a/phase steppers 2 drv8825 drivers, , want power 12v 'p' model firgelli (using linear actuator control board: http://www.firgelli.com/uploads/lac_datasheet.pdf):
1) how can connect single power supply 3 different drivers?
2) okay if supply single 12v 6a power supply 3 of these boards - 2 drv8825s , lac board?
3) also, supplying 6a different drivers damage them in way?
the reason have these questions because 3 of these drivers support 12v of voltage supply, don't know how current i'm allowed supply drivers.
i limit project using 1 power supply. i've included drawn diagram of setup below. in advance.
i'm finishing design project of mine, , want see if final idea feasible - if want power 2 12v, 1.3a/phase steppers 2 drv8825 drivers, , want power 12v 'p' model firgelli (using linear actuator control board: http://www.firgelli.com/uploads/lac_datasheet.pdf):
1) how can connect single power supply 3 different drivers?
2) okay if supply single 12v 6a power supply 3 of these boards - 2 drv8825s , lac board?
3) also, supplying 6a different drivers damage them in way?
the reason have these questions because 3 of these drivers support 12v of voltage supply, don't know how current i'm allowed supply drivers.
i limit project using 1 power supply. i've included drawn diagram of setup below. in advance.
you must connect arduino gnd ground of motor drivers !
the arduino board powered usb, can power power supply.
the 6a not problem, long 12v okay. 12v 6000a not problem.
you have take care wiring, when make shortcut, 6a can lot of damage.
the arduino board powered usb, can power power supply.
the 6a not problem, long 12v okay. 12v 6000a not problem.
you have take care wiring, when make shortcut, 6a can lot of damage.
Arduino Forum > Using Arduino > Project Guidance > Using the Right Power Supply Setup
arduino
Comments
Post a Comment