Skip to main content

Thread: IDE to Compact Flash Adpater for UDMA 5

-

hi,

i've brought transcend 600x 8gb compact flash card i'm intending use os disk mythbuntu system aid of ide cf adapter.

card supposedly transfers data @ 90mb/s first attempt use produced random speeds ending system becoming unusable.

i've figured due cheap ide cf adapter not supporting dma.

want buy new 1 work , @ full speed (in case udma 5)...

i've found page talks problems:


according need have right pins connected, resistors , grounding lines!

i've discovered card operate @ speeds greater udma 4 must run @ 3.3v (this buried in product's datasheet).

nearest adapter i've found 1 (it @ least has switchable voltage - not sure crosstalk issue):


question (well done if you're still reading) before spend more money has else got card working @ speed , adapter?


thanks,

cabbage.

just found this:


can have 1 device on bus , max cable length of 6 inches..!


Forum The Ubuntu Forum Community Ubuntu Official Flavours Support Hardware [all variants] IDE to Compact Flash Adpater for UDMA 5


Ubuntu

Comments

Post a Comment

Popular posts from this blog

Connecting Raspberry Pi 2 to P10(1R)-V706 LED Dot Matrix - Raspberry Pi Forums

-
Image
hello everyone, name kedi.. make system connecting raspberry pi 2 , arduino uno arduino adc of 1 dust sensor sharp gp2y1010au0f , 4 gas sensor. want show decision of air quality system in running text @ p10 16x32 led dot matrix display. in raspberry pi 2, connect p10 pins in gpio25, gpio12, gpio16, gpio13 & gpio26. now, i'm finish circuit , don't know must connect p10's vcc & ground (red & black wire). can me? , code in python controlling p10(1r)-v706 dot matrix?.. regards, kedi i can't python code (did mine in basic on risc os) regarding power, panels each require 2.5a, you'll need separate supply them. if attempted power them pi, pi's polyfuse blow immediately. alternatively, use supply capable of giving 10a supply both panels , pi. raspberrypi
Read more

TypeError: <unknown> is not a numpy array - Raspberry Pi Forums

-
hi, thank help. question simple: how convert raspistill data opencv processing. code: select all def capture(settings, width, height): command = "raspistill %s -w %s -h %s -t 200 -e bmp -n -o -" % (settings, width, height) imagedata = stringio.stringio() imagedata.write(subprocess.check_output(command, shell=true)) imagedata.seek(0) im = image.open(imagedata) buffer = im.load() imagedata.close() return im,buffer code: select all image1, buffer1 = capture(camerasettings, testwidth, testheight) cv2.imshow('image',image1) want use different opencv processing techniques, before need know doing wrong. bests svato raspberrypi
Read more

datso and removing imagetitle - Joomla! Forum - community, help and support

-
hello everybody i have installed datso v. 1.3.8 , remove imagetitles http://www.galleri-kbh.dk/index.php?opt ... ry&catid=2 on datsos  homepage there no names, can't find function in parameters in administration?? http://www.datso.fr/datsogallery/viewcategory/2.html can me. vh jan found way it  :d delete line 307 "$tle = ereg_replace('"', '', $row1->imgtitle);" in file components/com_datsogallery/datsogallery.php Board index Joomla! Older Version Support Joomla! 1.0 Extensions - 1.0.x Components
Read more